

Windlass chain counter, reading on mobile phone or tablet via bluetooth
Windlass chain counter, reading on mobile phone or tablet via bluetooth
Chain reading on Android phone or tablet, without installing complicated equipment with its possible breakdowns.
No configuration required, plug and play, always available, measures up to 500 meters.
Much simpler installation than any equipment on the market, no need to carry cables and cross the entire boat to the rudder.
Setting of anchoring up and down alarms.
Guaranteed after-sales service.
Most competitive price on the market.
Do I need an installer?
Installation does not present any difficulty, anyone without technical knowledge can install the SEYMO Chain Counter
You only have to connect the four cables to the windlass relay and it works.
.
In the App setup, configure how many Centimeters the gill develops in each turn.
Configure if you want an alarm for rising or falling.
Example of anchoring: Chain reading on phone or tablet 15.70 meters cast, already anchored, exit the App when you re-enter the App you will have the reading of the anchored chain and if the chain rises or falls the reading will be updated.
.
Android App
Reset to zero
Configuration of the development of the gill for the calculation of Meters.
Counts from 0 to 500 meters, with two decimals for more accuracy
Configuration of the rise alarm from 1 to 20 meters.
Configuration of the fall alarm from 10 to 99 meters.
Memory of meters cast when starting the App again.
Transmission system without data loss (Meters)
Range 30 meters
.
Disconnect the power supply from the windlass
Connect the Seymo to the windlass as indicated in the diagram,
Connect the power supply to the red cable +12V or 24 V according to the selection
And the black cable to the ground 0V.
Sensor cables
Yellow cable to the button or relay to lower the windlass
White cable to the button or relay to raise the windlass
.
Sensor
Control unit
Wiring
Android App
.
.
You might also like