

Automatic electronic switch for bilge pump
All the automatic switches that exist on the market are submerged in the bilge and eventually break down. They are expensive and cannot be repaired.
Why a Seymo Bilge Switch?
Automatic electronic bilge pump switch.
All automatic switches on the market are made of a single piece. Their sensor and electronics are submerged in the bilge. Over time, water enters and fails. They are expensive and cannot be repaired.
Our experience shows that the best option is to separate the processing unit from the sensor itself, thus achieving a much longer lifespan.
With a separate CPU installed higher up in a dry location, we ensure that water does not enter and stop it from working (although it has a two-year warranty and has no problems).
Seymo offers the option of repair without surprises at a fixed price of €20.
The completely waterproof and replaceable sensor is priced at an affordable price of €12.
The Seymo electronic switch consists of a separate sensor and processing unit, which sets it apart from others on the market.
Watertight sensor with no moving parts that cause wear and jamming.
Separate processing unit for extended life.
Pumps up to 25 Ah.
Negligible consumption: 0.04 mA.
12V or 24V depending on the selection.
LED indicator for bilge pump operation.
Low battery LED indicator: 10 Volts.
Low battery protection.
Works in both fresh and salt water.
Competitively priced.
8-second delay prevents the pump from switching on due to heeling. 15-second delay to completely empty the bilge. Innovative design.
Watertight, recessed sensor made of AISI 316 anti-corrosion material. Protected against exposure to solvents and corrosion from liquids in the bilge.
Installation:
The sensor is installed in the bilge.
The CPU is installed in a higher, drier location.
Includes:
CPU.
Sensor.
Wiring.
Manual.
Dimensions:
Sensor 50x50x20 mm.
CPU 80x50 mm.
You might also like